DCP_3148.JPG
4140 hits | 71.66 KB | Posted: 7/4/04
ZF S547 from a 1996 F350 4x4 with a 5.8L.

DCP_3147.JPG
2319 hits | 66.79 KB | Posted: 7/4/04

DCP_3150.JPG
2221 hits | 71.92 KB | Posted: 7/4/04

DCP_3157.JPG
7300 hits | 71.24 KB | Posted: 7/6/04
ZF S5-47 next to M5OD-R2

DCP_3154.JPG
3444 hits | 73.48 KB | Posted: 7/6/04
Interestingly, the ZF's output shaft looks to exit much higher than the M5OD's but viewing the two c...

DCP_3163.JPG
2156 hits | 44.9 KB | Posted: 7/18/04
resurfaced the flywheel

DCP_3164.JPG
2165 hits | 71.08 KB | Posted: 7/18/04
made these dowels to help installation

DCP_3166.JPG
2108 hits | 69.64 KB | Posted: 7/18/04
those dowels installed. I later cut 2" off of them and made another slot because of issues with inst...

DCP_3169.JPG
2099 hits | 55.48 KB | Posted: 7/18/04
crappy picture but I got it installed.
I was too busy to take pictures of the OSHA-violating contra...

DCP_3171.JPG
2047 hits | 51.87 KB | Posted: 7/18/04
Cross-member, T-case, drive shafts and bleed the clutch. After that, we'll see how it goes...

DCP_3179.JPG
2199 hits | 50.74 KB | Posted: 7/19/04
no clearance issues yet

DCP_3180.JPG
2276 hits | 70.83 KB | Posted: 7/19/04
crossmember installed