SuperMotors.net Forums

Forums > Car and Truck Make and Model Specific > Bronco, Bronco II

'88 Bronco fusible link problem

Thread Statistics:     Users to Post: 1   |   Total Posts: 1   |   Total Views: 1522

You must be logged in to post in or subscribe to this thread. Pages: 1

Laurits • Fort Walton Beach, FL, USA • Registered on 11/22/2016 • 6 posts • 1 Vehicle

Posted:7/30/2018 13:55 Hi, I need to ID two fusible links tied to the same connector ring. The factory blobs are marked P14 & P15. Leads going to the ring are both black. On circuit side of the factory blob it has one yellow lead and one black with a yellow stripe. The ring wire crimp shank is split both there are no signs of heat damage. I ran a continuity check from the ring to ground and got an almost dead short, that is it went 3/4 of the way up the scale.

Forums > Car and Truck Make and Model Specific > Bronco, Bronco II

'88 Bronco fusible link problem

Thread Statistics:     Users to Post: 1   |   Total Posts: 1   |   Total Views: 1522

You must be logged in to post in or subscribe to this thread. Pages: 1