IMG_0145.JPG
1832 hits | 80.33 KB | Posted: 11/29/04
The back seat of a Bronco is a black abyss. Since my 8" round mid range speakers eat up so much spac...

IMG_0146.JPG
1509 hits | 68.36 KB | Posted: 11/29/04
All I had to do was add a ground wire where the stock Mopar would have used the mounting hole to gro...

IMG_0149.JPG
1527 hits | 46.62 KB | Posted: 11/29/04
Added a male three pin plug for quick disconnects to both Chrysler dome lights(new Bronco rear seat ...

IMG_0154.JPG
1363 hits | 89.9 KB | Posted: 11/29/04
The female 3 pin plug I wired into the stock harness utilizing the no longer used rear speaker wires...

IMG_0162.JPG
1484 hits | 34.58 KB | Posted: 11/29/04
These plugs are available at any electronic surplus store real cheap and allow you to do this. Just ...

IMG_0003.JPG
1363 hits | 34.83 KB | Posted: 1/7/05
Here's your stock rear seat ashtray. On mine they've been rendered useless by my 8" mid range speake...

IMG_0007.JPG
1167 hits | 51.83 KB | Posted: 1/7/05
Whip out the ashtray and discard or sell on E-bay.

IMG_0012.JPG
1170 hits | 44.62 KB | Posted: 1/7/05
Remove and keep the ashtray mounting screws.

IMG_0015.JPG
1121 hits | 39.64 KB | Posted: 1/7/05
The ashtray housing gets the heave too.

IMG_0018.JPG
1088 hits | 46.01 KB | Posted: 1/7/05
As luck would have it the Fifth Avenue Dome housing screw centers are just a hair too narrow for the...

IMG_0021.JPG
1126 hits | 43.44 KB | Posted: 1/7/05
I did promise a bolt-on modification so here goes. A slightly larger/longer screw clip is employed ...

IMG_0026.JPG
1161 hits | 53.98 KB | Posted: 1/7/05
Trial fitting the Fifth Avenue dome light, with the larger screw clip (end of bad finger) in place.

IMG_0032.JPG
1226 hits | 60.35 KB | Posted: 1/7/05
After marking the clip, through light fixture's mounting hole, I drilled a hole in the screw clip. M...

IMG_0044.JPG
1392 hits | 45.91 KB | Posted: 1/7/05
Now you can run in the two screws, making this a true bolt on, not having ruined your original fine ...

IMG_0047.JPG
1686 hits | 34.54 KB | Posted: 1/7/05
Done, like dinner. I mounted the map light and switch pointing upward, for the rear seat passenger t...

IMG_0008.JPG
1138 hits | 56.43 KB | Posted: 11/27/05
Changed my mind and went with two more Bronco cargo area lights. Just needed to slice open the vinyl...

IMG_0010.JPG
1500 hits | 65.12 KB | Posted: 11/27/05
Then just slip in the Bronco cargo light.