DSC00173.JPG
550 hits | 51.05 KB | Posted: 8/3/03

cool exhaust tip... a lot better then 2" pipe bent up so it is barely open
DSC00174.JPG
550 hits | 59.48 KB | Posted: 8/3/03

Flowmasta!!! (40 series)
DSC00175.JPG
597 hits | 59.15 KB | Posted: 8/3/03

the new pipe in front of muffler was a 5" long exhaus leak
DSC00204.JPG
553 hits | 82.64 KB | Posted: 8/3/03

ripped off all the junk and putting on a 600 CFM Edelbrock and a new temp gauge and belts too
DSC00162.JPG
610 hits | 79.84 KB | Posted: 8/3/03

pic before the ripping off of the extra weight and extra vacumm leaks.
Picture 102.jpg
545 hits | 87.94 KB | Posted: 5/15/04

why I hate Edelbrock carbs. This was why my car idled like crap, didnt start but after 5 times and ...
Picture 103.jpg
437 hits | 92.98 KB | Posted: 5/15/04

It was like this when we unbolted it, no human error caused this. Just stress or the cold
Picture 104.jpg
407 hits | 61.96 KB | Posted: 5/15/04

pic with intake and drivers side valve cover off. The other side we had to cut the exhaust warmer t...
Picture 105.jpg
515 hits | 77.49 KB | Posted: 5/15/04

everythings off, it doesnt look bad in here except the drivers side has a lot of carbonized oil all ...
Picture 106.jpg
452 hits | 51.27 KB | Posted: 5/15/04

cleaned up Edl performer intake.
Picture 107.jpg
462 hits | 48.84 KB | Posted: 5/15/04

cleaning off the remaining crap with carb cleaner and a clean rag.
Picture 108.jpg
522 hits | 57.06 KB | Posted: 5/15/04

applyed gasket shalac to all but the ends and the water passages.
Picture 109.jpg
474 hits | 86 KB | Posted: 5/15/04

did the same to the engine side
Picture 110.jpg
509 hits | 71.58 KB | Posted: 5/15/04

High temp RTV on the ends and water ports
Picture 111.jpg
459 hits | 61.72 KB | Posted: 5/15/04

and again on the intake
Picture 112.jpg
472 hits | 64.09 KB | Posted: 5/15/04

stuck the gaskets to the intake minus the ends and pressed it into place. Then installed a few bolt...
Picture 113.jpg
507 hits | 56.11 KB | Posted: 5/15/04

ford blue.. it was either that or aluminum colored. I just quickly sanded it down and threw 2 coats...
Picture 005.jpg
496 hits | 63.28 KB | Posted: 5/16/04

all back together, new is the Performer intake, 600 CFM holley, distributor from an 80' Blazer, and ...
Picture 006.jpg
466 hits | 66.62 KB | Posted: 5/16/04

glamor shot of the new distributor.

Oh and I removed a bunch more smog stuff and put on new heate...

About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2024 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog