DCTrashman
 |
|
• Cheverly, MD, USA |
|
• Registered on 9/7/2008 |
|
• 2 posts |
|
|
|
 Posted:9/14/2008 10:31 |
|
|
|
New to fourm i have a 200 x with 2400,000 on the clock truck ran good and has driver perfect, yesterday ridding down locat road hit a bump and it shut off and wouldnt restart. I pluged my Mac Mentor scanner int ot it and it is as if no power to the computer it reads as if it not pluged in the truck. the trucks turns over but wont start proior to that it ran perfect. Any words of wisdom would be great. PS 2000 limited with v10. The only other thing is the over head display doesnt work it didnt be for this. |
|
monsta
 |
|
• The Big Island, HI, USA |
|
• Registered on 1/5/2002 |
|
• 1,056 posts |
• 2 Vehicles
|
|
|
Posted:9/18/2008 01:44 |
|
|
Get out your manual and find the fuel cutoff button. This inertia switch trips during a hard deceleration event (crash, etc) This cuts off the fuel supply.
Usually you just push it back in. I cannot recall exactly but I think it is behind the kick panel on the passenger side wall (right side).
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
 |
|
DCTrashman
|
|
• Cheverly, MD, USA |
|
• Registered on 9/7/2008 |
|
• 2 posts |
|
|
|
|
Posted:9/21/2008 08:50 |
|
|
|
Thanks Monsta Tried that on the side of the road, Ford said that the wiring to number 5 and 6 coil was shorted out and that caused the ecm to short out the fuse. They repaired the wiring and install new fuse all is good now. |
|
superduty59
 |
|
• Carmel, IN, USA |
|
• Registered on 3/2/2006 |
|
• 19 posts |
|
|
|
|
Posted:5/4/2009 20:05 |
|
|
|
I have 01 Ex w/7.3. Bought new, best vehicle I've ever owned. Lately if I don't drive for two or three days it is totally dead. No lights, won't unlock, zero power. Batteries are fairly new and check out good. I replaced alternator and starter recently but didn't help. I have 107K on the clock. Anyone have any ideas? |
|
LANDYOT
 |
 | 
• Subscriber since 11/23/2003 |
|
• Newport News, VA, USA |
|
• Registered on 7/15/2003 |
|
• 1,110 posts |
|
|
|
|
Posted:5/6/2009 19:50 |
|
|
|
If it were me, I'd have the dealer run a diagnostics check of the GEM (General Electronic Module). The GEM in my '01 V10 Ltd went bad & was replaced. BTW, if you get a new GEM, don't forget to get your key fobs reprogrammed AND have them give you the new access code. |
|
