SuperMotors.net Forums

Forums > SuperMotors Community Discussion > Engine and Drivetrain

How to take off an aluminum intake manifold

Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 1194

You must be logged in to post in or subscribe to this thread. Pages: 1

wes harding • houston, TX, USA • Registered on 12/28/2002 • 1 post • 1 Vehicle	Posted:10/11/2004 15:24 I have a 351w in my 82 bronco. I currently have a blown manifold gasket. I have taken everything off the manifold from carburetor to distributor. I have removed all the bolts the only place I am having a problem is how to pry the manifold off with out damaging it. I know aluminum can be soft and I don’t want to ruin my edelbrock manifold. Any help would be great.
Dave Brian • Torrance, CA, USA • Registered on 1/15/2005 • 4 posts • 2 Vehicles	Posted:1/15/2005 22:41 hard to say, but I'd try a rubber mallet and tap the carb base. a few times, not hard if that does not work just tapping around the flanges might loosen it... when you replace the gasket use never seeze best

Forums > SuperMotors Community Discussion > Engine and Drivetrain

How to take off an aluminum intake manifold

Thread Statistics:     Users to Post: 2   |   Total Posts: 2   |   Total Views: 1194

You must be logged in to post in or subscribe to this thread. Pages: 1