bronco-4-2006_017.jpg
11798 hits | 62.98 KB | Posted: 4/25/06
homemade tool to remove axle pivot bushings

bronco-4-2006_018.jpg
8516 hits | 63.51 KB | Posted: 4/25/06
12" length of 1/2" all-thread, 2.5" I.D. x0.25" thick pipe collar, 1/2" thick metal plate, 13/16" im...

bronco-4-2006_021.jpg
9482 hits | 61.4 KB | Posted: 4/25/06
Insert all-thread into bushing, place socket on side of bushing without metal lip (shown reversed in...

bronco-4-2006_033.jpg
8646 hits | 64.73 KB | Posted: 4/25/06
place collar on other side, then plate and attach nuts&washers

bronco-4-2006_029.jpg
7904 hits | 61.57 KB | Posted: 4/25/06
tighten nuts on both sides until they stop (100-120 ft.lbs.)

bronco-4-2006_037.jpg
8397 hits | 66.85 KB | Posted: 4/25/06
give a sharp blow with hammer, re-tighten nuts if needed

bronco-4-2006_038.jpg
8696 hits | 67.05 KB | Posted: 4/25/06
bushing will "pop" loose

bronco-4-2006_032.jpg
9515 hits | 68.54 KB | Posted: 4/25/06
reverse tool to install new bushing using washer under socket, hammer used only to keep bushing stra...