Steve83 > 1983 Ford Bronco > open folder Brakes & Hubs > hubparts-kingpin.jpg

File 39 of 183
Prev | Next

Share This
Url
Tag
Img
Thumb

hubparts-kingpin.jpg Kingpin Hub Parts This diagram shows a drive flange (pale yellow) where most have a hub lock. Ford 8.8" axle uses 10 lug studs D6AZ-1107-A ('83-00) Dana 44IFS uses 10 lug studs D6TZ-1107-A ('83-96) Ford TIB axle uses 10 lug studs F4UZ-1107-A ('94-96) Note that, to make the drawing easier, the axle tube (bright green) is shown inclined. But in actuality, it is perfectly horizontal, and the spindle (olive green) & stub shaft (red) are angled slightly down. See also: [url=https://www.supermotors.net/registry/media/1096490][img]https://www.supermotors.net/getfile/1096490/thumbnail/hubparts-bj.jpg[/img][/url] . [url=https://www.supermotors.net/registry/media/576903_1][img]https://www.supermotors.net/getfile/576903/thumbnail/alignmentfrontwheels.jpg[/img][/url]
hubparts-kingpin.jpg | Hits: 7672 | Posted on: 8/22/09 | View original size (132.71 KB)

Kingpin Hub Parts

This diagram shows a drive flange (pale yellow) where most have a hub lock.

Ford 8.8" axle uses 10 lug studs D6AZ-1107-A ('83-00)
Dana 44IFS uses 10 lug studs D6TZ-1107-A ('83-96)
Ford TIB axle uses 10 lug studs F4UZ-1107-A ('94-96)

Note that, to make the drawing easier, the axle tube (bright green) is shown inclined. But in actuality, it is perfectly horizontal, and the spindle (olive green) & stub shaft (red) are angled slightly down.

See also:
.