1967 Ford Bronco
| Owner: |
Dan Eger (All of this user's registries on SuperMotors) |
| From: |
Chatsworth, CA, U.S.A. (Other registries in CA) |
| Year, Make, & Model: |
1967 Ford Bronco (Other Ford Broncos) |
| Avatar: |
 |
| Clubs: |
SuperFord.org (Other vehicles in this club)
|
| Nickname: |
Bronchole (the hole that all my $ & time goes in) |
| Mileage: |
10500 |
| Engine: |
FOR SALE, Considering offers over $15,000.00
Over $5000.00 in receintly built motor:
-95 351W full roller motor
-Trickflow heads($1500 in parts)
-Fox body oil pan($150 in parts)
-Holley 4DI injection system($1100 in parts)
-Mallory billit distributer($170 in parts)
-BC Broncos ceramic coated headers($500 in parts)
-Super single - Magnaflow 2-2.25" in to 1-3"exhaust.($150 in parts)
-V6 Explorer radiator($150 in parts)
-Taurus Fan($50 in parts)
-Full custom serp belt setup. Started as Explorer serp setup and migrated from there to incorporate Mark VII Saganaw pump($300 in parts).
-Should be just under 400HP and just over 400 FtLb torque |
| Drivetrain: |
-Rebuilt 4R70W transmission
-Braumantor TCS controller ($550 in parts)
-Dana 20-T transfer case
>>Tera Low 3.15:1 gears ($830 in parts)
>>Modified/ground shift rods for true twin stick operation
>>Wild Horses HD output shaft ($430 in parts)
>>Tom's Bronco parts Twin Stick($150 in parts)
-Ford 9 inch rear axle with:
>>Strange radial ribbed econ-nodular iron case($240 in parts)
>>Detroit NASCAR locker($200 in parts)
>>Yukon alloy axles($275 in parts)
>>Dana 4.88:1 gears($180 in parts)
>>1.75 inch drum brakes($200 in parts)
>>Shaved & trussed HD housing
-Dana 44 stock EB front axle with:
>>Detroit soft locker($650 in parts)
>>Dana 4.88:1 gears($180 in parts)
>>RCV axles & joints($1400 in parts)
>>30 spline Warn locking hubs($180 in parts)
>>F150 disk knuckels($120 in parts)
>>Rolled the knuckles 13° to correct the caster with 0° (2° poly installed as 0°) C bushings
>>Extended radius arms built by me, simmilar to Lars Bars($150 in parts)
>>Balistic rod ends for raduis arms($150 in parts)
>>West Texas Off Road 1.5 inch ram assist($700 in parts)
>>4x4x2 power steering box
>>Lincoln Mark VII Saganaw power steering pump w/HP output mod
>>Bilstein 12 inch travel short body resovour 7100 shocks($500 in parts)
-Hydroboost brake system($400 in parts)
-Summit roll lock brake line locks F&R($100 in parts)
-4140 1.375 inch hex chromolly tie rod/draglink with 85 Shuvy ends($300 in parts)
-5.5 inch BC Bronco front coil springs($160 in parts)
-5.5 inch BC Bronco (Deaver) 11 leaf rear springs($450 in parts)
-Wild Horses 5/8 u-bolts and HD plates($90 in parts)
-Fiberglass cowl hood($250 in parts)
-Family roll cage ($400 in parts)
|
| Notes: |
I originally assembled in 6 weeks for Rubicon trip in 9/2003! Only part of original drive line that wasn't replaced at that point was the transmission. Also replaced the wire harness because the old harness was butchered beyond repair by the previous owner.
Future/in process modifications:
-Ford EFI conversion
Trails conquered:
Rubicon 9/2003, 9/2004, 9/2005, 9/2006, 8/2007
Pismo 10/2003 to present!!
Fright night hungry valley ORVA 10/03 to 10/2010
Glamis 11/2003
Octillo Wells 12/31/03, 12/31/06
TDS Desert safari 1996-2012 (RIP Jim Kuns)
Truckheaven 1996-present
Dummont Dunes 4/2004, 2/2007
HIgh Desert Roundup 2004 2006 2008 2009
Armogosa sand dunes 12/2004
Bald Mountian - Moonlight Madness 7/2005, 6/2006, 6/2007
Duesy/Eirshim August 2007-2011
BBBB 2006-2011
Monache Medows & Sherman Jeep Trail June 2012
Future trips planned:
Member:
Ventura County Axlesnappers
http://www.axlesnappers.net/
SoCalBroncos
http://autos.groups.yahoo.com/group/socalbroncos/
CORVA
http://www.corva.org/
Blue Ribbon Coalition
http://www.sharetrails.org/
United Four Wheel Drive Associations
http://www.ufwda.org/
National Rifle Association
http://www.nra.org/
General class Ham Radio operator: KI6MCO |
| Last Updated: |
9/25/2012 |
| Hits: |
69633 |
| Folder |
 |
 |
 |
Hits |
 |
Created |
Updated |
 My Bronchole | 0 | 0 | 0 | 0 | 0 | 8/3/03 | 9/23/04 | | Rubicon Pics of my old steed | 3 | 0 | 0 | 2,304 | 0 | 8/3/03 | 9/23/04 | | Litlerock dam | 6 | 0 | 0 | 7,449 | 0 | 8/3/03 | 5/18/05 | | Rubicon 9-28 to 10-3-2003 | 16 | 0 | 0 | 11,456 | 0 | 9/22/03 | 10/17/03 | | Glamis 2003 | 5 | 0 | 0 | 9,495 | 0 | 12/1/03 | 11/4/04 | | Parts for sale | 40 | 0 | 0 | 25,410 | 0 | 7/1/04 | 7/1/04 | | Rubicon Instructions | 6 | 0 | 0 | 3,778 | 0 | 9/22/04 | 6/21/05 | | Rubicon 9-26 to 9-30-2004 | 11 | 0 | 0 | 8,115 | 0 | 10/2/04 | 10/3/04 | | Moonlight Madness 2005 | 5 | 0 | 0 | 2,826 | 0 | 7/28/05 | 7/28/05 | | Rubicon 9-11 to 9-19-2001 | 5 | 0 | 0 | 3,305 | 0 | 8/9/05 | 8/9/05 | | Rubicon 8-14 to 8-19-2005 | 16 | 0 | 0 | 12,030 | 0 | 8/22/05 | 3/6/07 | | VCAS Crap | 9 | 0 | 0 | 12,171 | 0 | 3/13/06 | 5/30/08 | | tube core/fender support | 14 | 0 | 0 | 13,490 | 0 | 3/20/06 | 7/8/08 | | PM4WDC Crap | 21 | 0 | 0 | 11,781 | 0 | 3/20/06 | 2/26/08 | | Roll Cage concept | 5 | 0 | 0 | 6,379 | 0 | 4/20/06 | 4/20/06 | | Spring Break 3 | 10 | 0 | 0 | 5,496 | 0 | 3/7/07 | 3/7/07 | | Lockwood - Miller | 97 | 0 | 0 | 48,299 | 0 | 5/14/07 | 7/7/07 | | Dusy-Ershim | 12 | 0 | 0 | 9,402 | 0 | 7/13/07 | 9/12/07 | | D20 SHIFT RAIL MODS | 9 | 0 | 0 | 8,652 | 0 | 5/10/08 | 5/10/08 |
Maintenance & Modification Logs
This user hasn't added any log entries, yet.
|
|
.jpg)
