Harness_Installation_02.jpg 1250 hits | 101.36 KB | Posted: 10/6/06 The new wiring harness going in. By the time this picture was taken Bob had already wired in the rear of the car at the trunk. You can see the harness going along the driver's side. (Posted in: Painless Wire Harness)
Pedals_Installed_01.jpg 1524 hits | 94.14 KB | Posted: 10/6/06 Finally installed. Man it's sweet. Movement of the clutch pedal feels so nice and smooth and stable. It's awesome! (Posted in: Brake and Clutch pedal bracket upgrade)
Pedals_Installed_03.jpg 1481 hits | 87.33 KB | Posted: 10/6/06 Here I'm trying to show you the heim joint that Bob made for the clutch pedal. You can also see the new firewall insulation and the fuse box of the new wiring harness. (Posted in: Brake and Clutch pedal bracket upgrade)
Pedals_Installed_04.jpg 1380 hits | 89.84 KB | Posted: 10/6/06 Another heim joint that Bob made. (Posted in: Brake and Clutch pedal bracket upgrade)
PedalsInstalled_08.jpg 1519 hits | 85.87 KB | Posted: 10/8/06 Here's a better view of the heim joint and rod that Bob fabricated. (Posted in: Brake and Clutch pedal bracket upgrade)
PlenumInstalled_02.jpg 1048 hits | 74.92 KB | Posted: 10/8/06 The heater plenum installed in the Fairlane. (Posted in: Heater Plenum - Core & Blower)
NewHarness01.jpg 1451 hits | 97.91 KB | Posted: 10/8/06 The new fuse box installed on the firewall. You can also see the new firewall insulation. (Posted in: Painless Wire Harness)
Heater_Plenum 003.jpg 907 hits | 69.86 KB | Posted: 9/12/06 Now you can see it's part metal and part fiberous plastic. I replaced the original heater blower motor and the leaky heater core. Scrubbed the rust off and repainted it. (Posted in: Heater Plenum - Core & Blower)
HeaterVent_2.jpg 1109 hits | 87.5 KB | Posted: 10/8/06 This heater vent is made of cardboard. It had a big hole. Bob patched it with a fiberglass repair kit and then glued the seems which were also coming apart. It was Bob's first time working with fiberglass, but he did a great job. (Posted in: Heater Plenum - Core & Blower)
EngineCompartment_12-19-06 004.jpg 1836 hits | 99.6 KB | Posted: 12/19/06 If you look carefully, you can see the Painless Maxi Fuse which is a 50 amp fuse. It stands between the battery and the fuse block in case of a major electrical short. We had to relocate the voltage regulator behind the battery, because of the MSD bo... (Posted in: Painless Wire Harness)
