Ford harness connector rear.jpg 213 hits | 40.79 KB | Posted: 8/4/13 Step 3 - Remove the foam/rubber weather protection from the back of the connector. This is just pressed in place, and can be removed by placing your pick between the foam/rubber and the wires (or the foam/rubber and the edge of the connector), and pu... (Posted in: Connector Replacement)
Ford harness connector w keeper loosened.jpg 218 hits | 38.48 KB | Posted: 8/4/13 Step 2. - Once the keeper is loosened, remove it completely. (Posted in: Connector Replacement)
Ford harness connector w keeper removed.jpg 188 hits | 35.23 KB | Posted: 8/4/13 You can see the wires down inside of the connector. The wires are held in place by plastic tabs (clips) down inside. (Posted in: Connector Replacement)
Ford harness connector.jpg 270 hits | 32.67 KB | Posted: 8/4/13 This is a typical underhood/chassic Ford harness connector. It's made up wires, a rubber weather-tight piece, the plastic connector, and a red plastic keeper.
Tools needed - preferably a small pic, but a tiny flat-head screwdriver will work, also.
... (Posted in: Connector Replacement)
Ford harness connector w weather tight removed.jpg 258 hits | 37.22 KB | Posted: 8/4/13 Here you can see foam/rubber piece removed. You can also see the plastic tabs that hold the wires in place (circled).You cant pull the wires out until Turn the piece back over to get access to the tabs/clips. (Posted in: Connector Replacement)
Ford harness connector clips.jpg 256 hits | 30.23 KB | Posted: 8/4/13 View from the front side. These are the tabs that hold the wires in place. There is one tab for each wire. The tabs press up against the metal connector on the wire (see next pic). These tabs are very brittle.
Step 4 - Very carefully slide your pic... (Posted in: Connector Replacement)
road trip ranchero 041.jpg 430 hits | 118.47 KB | Posted: 10/10/11 just getting started (Posted in: pictures)
road trip ranchero 039.jpg 469 hits | 120.38 KB | Posted: 10/10/11 floor pans in better than original it's been a slow hard job but coming along fast... (Posted in: pictures)
1964 Ford 012.JPG 386 hits | 87.58 KB | Posted: 10/10/11 in the booth ready (Posted in: pictures)
1964 Ford 014.JPG 389 hits | 91.54 KB | Posted: 10/10/11 ready to be cut and polished very straight now (Posted in: pictures)
1964 Ford 001.JPG 373 hits | 74.01 KB | Posted: 10/10/11 hood/doors/frt fender ready to bolt on (Posted in: pictures)
RATHOLE 023.JPG 285 hits | 102.61 KB | Posted: 3/30/12 It's out of the paint shop time for running gear and suspention! (Posted in: pictures)
RATHOLE 028.JPG 278 hits | 72.71 KB | Posted: 3/30/12 It's as streight as you can get! (Posted in: pictures)
RATHOLE 026.JPG 302 hits | 97.12 KB | Posted: 3/30/12 They laid the paint on nice. reflection is deep and clear. (Posted in: pictures)
