DSC02096a.jpg
1135 hits | 72.37 KB | Posted: 12/5/04
I used a 3" hole saw to cut the fender. The exhaust shop did a good job of centering the pipe.

DSC02097a.jpg
998 hits | 46.22 KB | Posted: 12/5/04
I asked him to leave it tucked behind the fender.

DSC02098a.jpg
972 hits | 72.57 KB | Posted: 12/5/04
Unfortunately the exhaust moves around when it heats up...

DSC02099a.jpg
1053 hits | 71.13 KB | Posted: 12/5/04
I think this is clearanced enough. I may make an aluminum plate to clean up the area a bit.

DSC02100a.jpg
1002 hits | 52.62 KB | Posted: 12/5/04

DSC02101a.jpg
1023 hits | 59.28 KB | Posted: 12/5/04

DSC02102a.jpg
1036 hits | 60.89 KB | Posted: 12/5/04

DSC02109a.jpg
1051 hits | 57.44 KB | Posted: 12/5/04

DSC02111a.jpg
1138 hits | 56.01 KB | Posted: 12/5/04