internet 5.jpg 371 hits | 57.66 KB | Posted: 1/12/08 This is before the fender flares were put on.
comparing the 2 leafs.jpg 258 hits | 32.77 KB | Posted: 2/16/08 The old leaf spring and the new Procomp 6" leaf spring. Notice the old pack has a broken leaf.
4 inches before lift.jpg 242 hits | 30.91 KB | Posted: 2/16/08 Before the rear lift it measured almost 43" to the bottom of the fender flare.
4.5 inches after lift.jpg 253 hits | 25.61 KB | Posted: 2/16/08 After the rear lift it measured over 45.5" It went up almost 3 inches.
after new rear leafs.jpg 302 hits | 31.1 KB | Posted: 2/16/08 The rear lift is all done. Now it sits a little higher in the rear.
before lift.jpg 270 hits | 35.89 KB | Posted: 2/16/08 This is what I started out with. A $200 Bronco.
cutting the old spring.jpg 364 hits | 41.16 KB | Posted: 2/16/08 It was suggested to cut the bolt off on either side of the spring, between the spring and shackle. ...
fender flares.jpg 3297 hits | 35.31 KB | Posted: 2/16/08 Fender flares on, but sagging in the rear. The lift used the stock wedge and a 4" block in the rear...
old and new carb.jpg 594 hits | 55.24 KB | Posted: 2/16/08 I replaced the old Edelbrock with a Holley Truck Avenger.