KLZE block
Millenia S rods
Diamond 8:7:1 compression forged pistons
Ported KLZE heads with interprep valve springs
Ported and polished and race polished KLZE intake from xtremethings.com
Candy blue mazda valve covers from xtremethings.com
Bored 65mm throttle body
Custom turbo pipes
T3/T4 50 trim turbo
New custom very effiicient intercooler
Custom intercooler pipes
Megasquirt standalone engine management system
Mitsubishi eclipse 1st gen blow off valve
Tial wastegate at 9 psi currently
Mazdaspeed oil cap
Royal Purple engine oil
MSD 6AL custom ignition system
MSD blaster 2 coil
NGK plug wires
NGK spark plugs
Jacobs ignition coil wire
Huge super cool turbo blanket
Aeromotive fuel pressure regulator
Subaru Sti 550cc injectors
Dual feed fuel system
Walbro 255 fuel pump
3 inch exhaust pipe
Magnaflow hi flow catalytic coverter
Standard Turbo Muffler
Nitrous express ntercooler spray system
Drivetrain:
Mazda MX6 manual transmission with better gearing for the 1/4 mile
Limited slip differential
PRD shorth throw shifter
Royal Purple transmission oil
Mevotech ball joints
Chrome Swirley Pgt wheels
Stock flywheel lightened to 12 lbs
Southbend stage 3 clutch
Notes:
Was bought from a friend.. vehicle is in very good condition inside and out... Car made 300 horsepower at the wheels 2 years ago on 10psi.. Car has new mods now and is estimated at 400 horsepower at the wheels at 12 psi..
Car also has custom "turbo" badges in place of the original ford badges as well as Rare tail lights from the UK
New dyno results coming soon!!!
Royal Purple's Ice coolant additive
Battery relocated to trunk
Custom gauges in the interior.( boost, oil pressure, water temp, air/fuel ratio and fuel pressure)
KLZE-Powered-05.jpg 4346 hits | 98.05 KB | Posted: 6/16/09 A nice pic of the ported and show polished klze intake manifold
convertible ford probe.jpg 3477 hits | 34.08 KB | Posted: 10/22/09 its not very often that you see a convertible ford probe lol, they are pretty rare because they were never a factory option.. This job was custom
100_1151.JPG 1563 hits | 80.73 KB | Posted: 8/26/09 new pic of the new piping
100_1266.JPG 1475 hits | 53.89 KB | Posted: 10/22/09 Here you can see where the axles go... as you can see in the pic you can see straight thru the tranny.. On stock strannies there is a differential that goes in between the shafts.. On this one you can see all the way thru.. that is how you can tell i...
100_1267.JPG 1474 hits | 71.91 KB | Posted: 10/22/09 side view of new jdm ld tranny
100_1149.JPG 1351 hits | 71.25 KB | Posted: 8/26/09 here is a close up of the new intercooler and new piping.. as you can see it barely fits... the pics would have came out better but its cloudy out today
