2013-06-16_09-37-02_905.jpg
352 hits | 77.43 KB | Posted: 6/16/13
Underside of the cover. The green webbing in the center runs all around the perimeter, wrapped in the fabric. This was for strength and durability.

2013-06-16_09-38-53_80.jpg
333 hits | 84.01 KB | Posted: 6/16/13
closeup of the seam and the snaps.

2013-06-16_09-49-39_603.jpg
312 hits | 73.09 KB | Posted: 6/16/13
Here's the rail. Snaps every 8", except at the rear. Small eye hooks for cargo and the bikini straps, and a marine hinge for the tubing that will support the bikini top.

2013-06-16_09-50-14_493.jpg
283 hits | 64.12 KB | Posted: 6/16/13
Closeup of the tubing hinge, snaps, and the eye.

2013-06-16_09-50-28_69.jpg
279 hits | 74.54 KB | Posted: 6/16/13

2013-06-16_09-50-55_582.jpg
302 hits | 72.5 KB | Posted: 6/16/13
Corner re-inforcement

2013-06-16_09-53-27_553.jpg
267 hits | 68.1 KB | Posted: 6/16/13
The start of the bikini top. The green webbing goes to the front, attaching to snap studs on the body. The black strap is sewn into the left and right sides, then hooks to eye at the rear of the rail. Buckles and parachute clasps ensure tension an...

2013-06-16_09-53-38_148.jpg
303 hits | 75.27 KB | Posted: 6/16/13
The start of the bikini top. The green webbing goes to the front, attaching to snap studs on the body. The black strap is sewn into the left and right sides, then hooks to eye at the rear of the rail. Buckles and parachute clasps ensure tension an...

2013-06-15_11-45-08_372.jpg
304 hits | 85.56 KB | Posted: 6/16/13
Here the seat's folded up and the cover is snapped to the forward bow.

128.jpg
638 hits | 95.35 KB | Posted: 9/10/12
How she sits now. There's also a 2" block in the rear to level out the ride, there used to be definite nose-up stance.

Bumper_23.jpg
446 hits | 49.8 KB | Posted: 4/26/12
I picked up a Rough Country 12000 lb with sythentic line and cover from 4x4 Group Buy (http://www.4x4groupbuy.com) for a really reasonable price. Wireless remote included. Installation, including electrical and two trips to the hardware store the get...

Start.jpg
407 hits | 25.9 KB | Posted: 4/26/12

Bumper_03.jpg
383 hits | 56.33 KB | Posted: 4/26/12
This is from the next day. Corner pieces are welded on, and diamond tread is attached to give me a standing surface when I'm working on the engine.

107.jpg
378 hits | 72.3 KB | Posted: 9/10/12
Rear utility lights. This is basically a manual switch for the backup lights. Handy when camping.

111.jpg
377 hits | 90.71 KB | Posted: 9/10/12
Rear lights fired up.

106.jpg
373 hits | 74.33 KB | Posted: 9/10/12
Grill lights (L) and LightBar (R). And they're lighted, too. Handy reminder to turn them off. Not horribly bright at night, either.

110.jpg
368 hits | 83.84 KB | Posted: 9/10/12
Lightbar and grill lights, all lit up. This pic was taken about 9am

176.jpg
363 hits | 39.61 KB | Posted: 9/11/12
I covered the little pocket to the right of the steering wheel with a small piece of aluminium, painted it, and carefull cut a hole for an ARB compressor switch. I'll be getting ARB air lockers in the future, and I will put them right here when that...