KIMG0101.jpg
124 hits | 53.33 KB | Posted: 6/16/16
Because i swapped the bench seat out for captains chairs, the old seat belts didnt have the sleeves ...

KIMG0102.jpg
122 hits | 63.61 KB | Posted: 6/16/16
using a T50 torx bit the belt came easily off

KIMG0103.jpg
124 hits | 51.58 KB | Posted: 6/16/16
new sleeve from Jeffs Bronco Graveyard were about 20$ each

KIMG0104.jpg
110 hits | 40.47 KB | Posted: 6/16/16
the hardest part is getting the square metal through that folded section. we will need to grind the ...

KIMG0105.jpg
172 hits | 93.36 KB | Posted: 6/16/16
feed a durable rope through the sleeve so we can pull the belt through. even after grindingt he corn...

KIMG0106.jpg
136 hits | 50.63 KB | Posted: 6/16/16
metal tab before grinding

KIMG0107.jpg
138 hits | 46.46 KB | Posted: 6/16/16
metal tab after grinding the corners off

KIMG0108.jpg
131 hits | 94.74 KB | Posted: 6/16/16
tie the rope to the metal tab. feed the belt in. make sure the buckle is facing the correct directi...

KIMG0109.jpg
133 hits | 88.31 KB | Posted: 6/16/16
pull it through most you can. may heat up the plastic lightly to make it more flexable. i left mine ...

KIMG0111.jpg
153 hits | 55.76 KB | Posted: 6/16/16
while im pulling it through im also straightening the plastic out to assist making it easier

KIMG0110.jpg
174 hits | 69.74 KB | Posted: 6/16/16
got it through. untie the knot and put tab back inside

KIMG0112.jpg
147 hits | 47.91 KB | Posted: 6/16/16
did both sides making sure the buckles were facing the right direction

KIMG0113.jpg
149 hits | 40.9 KB | Posted: 6/16/16
mount the buckles in the direction you need to clear center console. mine were still loose but the s...