1983 Ford Bronco Spark Plug Wire Repair pictures, videos, and sounds


Hits: 2258 Size: 47.66 KB Posted: 10/27/07 If a spark plug wire breaks at the end, or if it fails a resistance check and the fault is found nea...	Hits: 2075 Size: 42.43 KB Posted: 10/27/07 Forcefully push the wire farther into the boot. It may be necessary to twist or pull it first if th...	Hits: 2061 Size: 39.82 KB Posted: 10/27/07 Once the wire extends from the plug end of the boot a few inches, open the clamp section of the term...	Hits: 1796 Size: 39.6 KB Posted: 10/27/07 Carefully remove the outer insulation from the end of the plug wire. Don't cut any more than necess...	Hits: 1863 Size: 34.01 KB Posted: 10/27/07 Fold the conductor over the end of the insulation and insert it into the clamp end of the terminal s...
Hits: 1838 Size: 33.68 KB Posted: 10/27/07 Fold the conductor over the end of the insulation and insert it into the clamp end of the terminal s...	Hits: 2015 Size: 33.52 KB Posted: 10/27/07 Bending each side a little at a time, close the clamp ends into the wire insulation as tightly as po...	Hits: 1810 Size: 49 KB Posted: 10/27/07 VERY slowly, pull the boot back down the wire toward the terminal.	Hits: 1820 Size: 48.96 KB Posted: 10/27/07 The wire will move more easily when the terminal goes through the bend (where it should stop), so wo...	Hits: 1955 Size: 48.37 KB Posted: 10/27/07 The terminal will lie flat inside the boot when it reaches the proper position. Before reinstalling...