|
|
Hits: 371
Size: 92.58 KB
Posted: 3/16/24
Door & Ignition Lock Cylinder Replacements
IF THE IMAGE IS TOO SMALL, click it.
For any '80-96/7 F-... | 
Hits: 305
Size: 44.85 KB
Posted: 3/16/24
Instruction Sheet for Ford (StratTech) 8-cut ignition lock cylinder assembly
IF THE IMAGE IS TOO SM... | 
Hits: 274
Size: 44.59 KB
Posted: 3/16/24
Door Lock Cylinder Replacement
IF THE IMAGE IS TOO SMALL, click it.
In addition to removing all ... | ![Key-In Contact Repair
[url=https://www.supermotors.net/registry/media/1092884][img]https://www.supe...](https://www.supermotors.net/getfile/1045646/thumbnail/buzzkey.jpg)
Hits: 3432
Size: 139.11 KB
Posted: 1/4/15
Key-In Contact Repair
[url=https://www.supermotors.net/registry/media/1092884][img]https://www.supe... | 
Hits: 1570
Size: 114.15 KB
Posted: 9/3/14
This original '93 collar (using the 10-cut key) is very loose, causing several annoying problems. W... |
Hits: 1106
Size: 114.98 KB
Posted: 9/3/14
If the key-in switch is damaged, it can be discarded. This one is OK, so I removed it carefully.
[... | 
Hits: 1002
Size: 103.36 KB
Posted: 9/3/14
The cylinder must be rotated back to OFF before rotating forward past START to disassemble it from i... | 
Hits: 979
Size: 109.05 KB
Posted: 9/3/14
As the cylinder passes START, the cam on the end will disengage from the mating cam in the housing, ... | 
Hits: 936
Size: 107.69 KB
Posted: 9/3/14
Note the orientation of the detent ring as it falls off. Don't lose the brass detent springs & pins... | 
Hits: 992
Size: 110.14 KB
Posted: 9/3/14
Inspect all the working parts of the cylinder. If it's damaged or worn, don't waste your time tryin... |
Hits: 881
Size: 107.37 KB
Posted: 9/3/14
Use brake cleaner liberally (in a ventilated area where the overspray & drips won't damage anything)... | 
Hits: 935
Size: 102.37 KB
Posted: 9/3/14
Insert the key, align the collar perfectly, mark the collar to the cylinder, and remove the key whil... | 
Hits: 898
Size: 105.15 KB
Posted: 9/3/14
Apply glue to a small area and allow it to dry while holding alignment. Recheck, and if necessary, ... | 
Hits: 896
Size: 93.88 KB
Posted: 9/3/14
Once they're glued together in one spot, fill the gap between the collar & cylinder, allowing the gl... | 
Hits: 852
Size: 106.55 KB
Posted: 9/3/14
Once the glue is thoroughly dry, and you're satisfied with the alignment, apply light oil to the cyl... |
Hits: 989
Size: 105.48 KB
Posted: 9/3/14
Insert the cylinder back into the housing, aligning the cams at the inner end, then rotate the cylin... | | | | |
Lock Cylinder