20150202_185040.jpg
333 hits | 63.86 KB | Posted: 2/3/15
Found a cross threaded wheel stud on my 8.8. Not sure if I did this, or if it was the shop that put ...

20150202_185413.jpg
389 hits | 47.65 KB | Posted: 2/3/15
5 lb sledge made quick work of the old stud, plenty of clearance behind the end of the axle shaft.

20150202_185423.jpg
401 hits | 57.9 KB | Posted: 2/3/15

20150202_185428.jpg
336 hits | 59.43 KB | Posted: 2/3/15

20150202_185439.jpg
328 hits | 35.16 KB | Posted: 2/3/15
and it's out..you can see how chewed up the threads are..

20150202_185633.jpg
397 hits | 65.67 KB | Posted: 2/3/15
used a bit of grease around the knurled part of the stud to help it go in easier.

20150202_185817.jpg
406 hits | 55.04 KB | Posted: 2/3/15
used a stack of some thick washers so I could pull the stud into the shaft.

20150202_190706.jpg
411 hits | 47.76 KB | Posted: 2/3/15
hitting it with my impact gun.

20150202_190711.jpg
460 hits | 60.63 KB | Posted: 2/3/15
this is my cheap HF impact, but it got the job done, was able to draw the stud flush with the back o...

20150202_190910.jpg
385 hits | 60.3 KB | Posted: 2/3/15
Finished product.

20150202_190914.jpg
434 hits | 52.29 KB | Posted: 2/3/15