IMG_20180510_112617223.jpg
271 hits | 37.67 KB | Posted: 5/11/18
Track bar repair stud for the dana44 solid axle from Bronco Graveyard. Used to address the problem w...

IMG_20180518_153725070.jpg
190 hits | 66.8 KB | Posted: 5/21/18
test fitting..

IMG_20180518_155309724.jpg
192 hits | 70.14 KB | Posted: 5/21/18
getting closer.

IMG_20180518_160241435.jpg
193 hits | 71.53 KB | Posted: 5/21/18

IMG_20180518_160559311.jpg
226 hits | 68.25 KB | Posted: 5/21/18

IMG_20180518_160600478.jpg
198 hits | 69.23 KB | Posted: 5/21/18
Not sure if I went too far with the reamer or what, but this is what it looked like before I got the...

IMG_20180518_160738173.jpg
202 hits | 63.22 KB | Posted: 5/21/18

IMG_20180518_160946151.jpg
189 hits | 62.3 KB | Posted: 5/21/18
back of the mount and the tapered washer.

IMG_20180518_170226805.jpg
202 hits | 58.87 KB | Posted: 5/21/18
this is what happened when I got the back tightened down..It pulled the tapered part of the stud fur...

IMG_20180518_170235260.jpg
203 hits | 59.44 KB | Posted: 5/21/18

IMG_20180519_102205663.jpg
206 hits | 50.56 KB | Posted: 5/21/18

IMG_20180519_102218380.jpg
223 hits | 61.56 KB | Posted: 5/21/18
from the back. I had to use another washed in order to get this tight enough..used an impact gun to ...

IMG_20180519_102226504.jpg
206 hits | 60.3 KB | Posted: 5/21/18