lftside.JPG 1489 hits | 26.94 KB | Posted: 6/29/03 Here is a shot showing the whole left side. It doesn't look too bad so far. Both sides are trimmed. Now to figure out how I'll finish it.
cutoutright2.JPG 1446 hits | 22.73 KB | Posted: 6/29/03 Here is the right side fender cut out to the tape marking. You can just barely make out the inner fender. There is no turning back now.
tapedfender2.JPG 1322 hits | 28.67 KB | Posted: 6/29/03 Here is the left side taped for trimming. I had to use a slightly differant angle because of glare. Notice the hole near the front.
tapedfender.JPG 1336 hits | 29.01 KB | Posted: 6/29/03 Here is the left fender after taping. I have hopefully left enough meat fron and rear to bend it inward.
fenderrust.JPG 1223 hits | 19.59 KB | Posted: 6/29/03 I thought I was just sanding off a few rust bubbles. As you can see I got rid of the rust. Now I have a hole.
installedguard.JPG 1196 hits | 22.29 KB | Posted: 6/29/03 Here is the Rock slider installed. The shot is take looking up at the drivers side.
rockbarhole.JPG 1272 hits | 25.92 KB | Posted: 6/29/03 Here is the 'Rock slider' that will reinforce my rocker panels. The cutout for the seatbelt bolt was done with an angle grinder. (Wife's Jeep in background)
broncorear.JPG 1145 hits | 18.56 KB | Posted: 6/29/03 Another shot of pre-modified Bronco.
Most Viewed Files
lftside.JPG 1489 hits | 26.94 KB | Posted: 6/29/03 Here is a shot showing the whole left side. It doesn't look too bad so far. Both sides are trimmed. Now to figure out how I'll finish it.
cutoutright2.JPG 1446 hits | 22.73 KB | Posted: 6/29/03 Here is the right side fender cut out to the tape marking. You can just barely make out the inner fender. There is no turning back now.
tapedfender.JPG 1336 hits | 29.01 KB | Posted: 6/29/03 Here is the left fender after taping. I have hopefully left enough meat fron and rear to bend it inward.
tapedfender2.JPG 1322 hits | 28.67 KB | Posted: 6/29/03 Here is the left side taped for trimming. I had to use a slightly differant angle because of glare. Notice the hole near the front.
rockbarhole.JPG 1272 hits | 25.92 KB | Posted: 6/29/03 Here is the 'Rock slider' that will reinforce my rocker panels. The cutout for the seatbelt bolt was done with an angle grinder. (Wife's Jeep in background)
fenderrust.JPG 1223 hits | 19.59 KB | Posted: 6/29/03 I thought I was just sanding off a few rust bubbles. As you can see I got rid of the rust. Now I have a hole.
installedguard.JPG 1196 hits | 22.29 KB | Posted: 6/29/03 Here is the Rock slider installed. The shot is take looking up at the drivers side.
broncofront.JPG 1153 hits | 19.83 KB | Posted: 6/29/03 Here is my Bronco before any modifications.
