|
|
because i have a Quarterhorse tuner, i can datalog. i let the truck idle for several minutes till fully warmed up and datalogged it for a time which turned out to be 78 seconds. after installing the screen, i did the same to keep it as similar to a test as possible.
as you can see the sensor previously had alot of noise and even some fluctuations due to the idle not being perfectly steady. however after the screen was installed, you can see the noise is very minimal and the fluctuations are all gone.
before it was jumping frequently above 0.8v and below 0.5v sometimes dropping below 0.4v which is a huge change. now its very steady 0.7v and not going any lower than 0.67v or higher than 0.75v which is very god compared to before
|
