|
|
dscf3571--cargo-area-rust-bulleted.jpg | Hits: 39 | Posted on: 11/4/21
| View original size (109.42 KB)
Rust Bullet applied to bed sides. I poured out a little too much, and with how fast it dries, didn't want to ruin the rest of the stuff in the can by pouring the extra back in, so I used it on the unpainted/rusted spot where the tailgate access panel sat during factory paint work. It had been rust prepped and vacuumed, but not fully prepped for good adhesion, so it's debatable whether it was worth doing. I can always sand down and redo it later...
Also, as soon as I run the tank a bit lower, I'm going to drop it and see if I can push up the dent from below, then do some reinforcements. If that works and I don't have to do a full replacement of the bed, having that section Rust Bulleted seemed worthwhile even if it doesn't hold up quite as long as a properly prepped coat would.
|
