File 8 of 8
Prev | Next

p1250012.jpg | Hits: 4725 | Posted on: 1/25/07 | View Low-Res

The entire hub assembly swap will take 60-90 minutes and is very straight-forward.

Remove the retaining/c-clip from the hub
http://www.supermotors.net/vehicles/registry/media/431287

Remove the hub from the dana 50 front axle
http://www.supermotors.net/vehicles/registry/media/431288

Remove axle c-clip from dana 50 front axle
http://www.supermotors.net/vehicles/registry/media/431289

Remove the 3 washers from the axle
http://www.supermotors.net/vehicles/registry/media/431290

Remove nuts on back of hub assembly
http://www.supermotors.net/vehicles/registry/media/431318

Disconnect the ABS line
http://www.supermotors.net/vehicles/registry/media/431320
The new hub assembly comes with a new ABS cable already connected to it. Simply follow the line back to the plug on the inside of the fender and disconnect.

Tap and pry loose the hub assembly
http://www.supermotors.net/vehicles/registry/media/431359

Install your new hub assembly (don't forget to get a new o-ring (the yellow one). You can view a re-installation video from my ball joint article here: http://www.supermotors.net/vehicles/registry/media/431385