File 63 of 133
Prev | Next

Share This
Url
Tag
Img
Thumb

tsb941708dashnoise.jpg TSB 94-17-08 Dash Noise

LIGHT TRUCK: 1992-94 BRONCO, F SUPER DUTY, F-150-350 SERIES

ISSUE: Some vehicles may exhibit a "squeak" coming from the instrument panel in the upper right and/or left hand corners. This may be caused by instrument panel coming in contact with the cowl top sheet metal.

ACTION: Remove a small triangular piece of the material from the top right hand and/or left hand side instrument panel. Refer to the following for service details.

SERVICE PROCEDURE
1. Determine if the squeak is coming from one or both sides of the instrument panel.
2. Remove the "A" pillar trim moulding(s) as required.
3. Scribe a line from the side edge to the top edge of the instrument panel as shown.
4. Trim the instrument panel, remove and discard the triangular shaped piece(s).

NOTE: DO NOT EXCEED THE MEASUREMENTS OR THE SIZE OF THE PIECE TO BE REMOVED. IT WILL CAUSE A CUSTOMER APPEARANCE CONCERN WHICH MAY RESULT IN THE REPLACEMENT OF THE INSTRUMENT PANEL.

5. Install the "A" pillar moulding(s) as required.

For other TSBs, check [url=http://www.revbase.com/BBBMotor/]here[/url].

See also:
[url=http://www.supermotors.net/registry/media/498379][img]http://www.supermotors.net/getfile/498379/thumbnail/dash9296.jpg[/img][/url]
tsb941708dashnoise.jpg | Hits: 7799 | Posted on: 3/17/07 | View original size (137.55 KB)

TSB 94-17-08 Dash Noise

LIGHT TRUCK: 1992-94 BRONCO, F SUPER DUTY, F-150-350 SERIES

ISSUE: Some vehicles may exhibit a "squeak" coming from the instrument panel in the upper right and/or left hand corners. This may be caused by instrument panel coming in contact with the cowl top sheet metal.

ACTION: Remove a small triangular piece of the material from the top right hand and/or left hand side instrument panel. Refer to the following for service details.

SERVICE PROCEDURE
1. Determine if the squeak is coming from one or both sides of the instrument panel.
2. Remove the "A" pillar trim moulding(s) as required.
3. Scribe a line from the side edge to the top edge of the instrument panel as shown.
4. Trim the instrument panel, remove and discard the triangular shaped piece(s).

NOTE: DO NOT EXCEED THE MEASUREMENTS OR THE SIZE OF THE PIECE TO BE REMOVED. IT WILL CAUSE A CUSTOMER APPEARANCE CONCERN WHICH MAY RESULT IN THE REPLACEMENT OF THE INSTRUMENT PANEL.

5. Install the "A" pillar moulding(s) as required.

For other TSBs, check here.

See also:
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2024 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog