broncofocused > 1993 Ford Bronco > open folder Soft Top Fab & Install > mount-bracket-fabrication-(2).jpg

File 7 of 14
Prev | Next

Share This
Url
Tag
Img
Thumb

mount-bracket-fabrication-(2).jpg I then tightened up the bend with a hammer. Not very professional, but highly affective. Initially I did use a small torch to put some heat into the aluminum before bending, but it didn't appear to make any difference in the process.
mount-bracket-fabrication-(2).jpg | Hits: 1916 | Posted on: 5/20/07 | View original size (138.11 KB)

I then tightened up the bend with a hammer. Not very professional, but highly affective. Initially I did use a small torch to put some heat into the aluminum before bending, but it didn't appear to make any difference in the process.