'93-95 Bronco Engine Bay LHR
IF THE IMAGE IS TOO SMALL, click it.
This cruise servo was only used from '93-04.
Only '93-96 Broncos have 4WABS.
'96-up DLC is under the dash.
To remove the EEC, back out the 10mm bolt recessed in the center of its connector, set the connector aside, remove the 2 11mm nuts (above & below), then pull the EEC & its weather seal straight forward into the engine bay. It may be necessary to bend the plastic wheelwell liner to make room.
See also:
.
.
.
.
.
.
.
See also:
MotorCraft 2016 Wiring Pigtail Guide 
