mRdot > 2007 Ford Crown Victoria
2007 Ford Crown Victoria
| Owner: |
mRdot (All of this user's registries on SuperMotors) |
| From: |
, MN, U.S.A. (Other registries in MN) |
| Year, Make, & Model: |
2007 Ford Crown Victoria (Other Ford Crown Victorias) |
| Avatar: |
 |
| Nickname: |
SOLD |
| Mileage: |
88800 |
| Engine: |
Complete factory black highway patrol 2007 Crown Victoira
bought at auction from the State of M at 88800 miles/2500 hrs
SOLD: Car will still be in Minnseota!
Included in Auction:
Rear Door Rods Half Installed (Inside Handle Rods In Trunk)
Keyless Entry/Lock
Idle Switch Remove Key In Park Locking Shift Interlock
Ford Police Trunk Deck With Side Storage Bins
Ford Police Truck Pack
Strobe Lights
Almost All Police Wiring
Modifications:
Ford Crown Victoria LX 2003 Dual Power Seats
Ford Crown Victoria LX 2003 Rear Seat
Ford Crown Victoria LX Passenger Side Kick Panel
Ford Crown Victoria LX Dash Trim
Ford Crown Victoria OEM Ash Tray/Cup Holder
GPS Puck Antenna (Larsen LP420NMO)
2003 Unity Spot Light (No handle)
Added fire extinguisher bracket and fire extinguisher.
Removed/Sold:
Ford OEM Police Trunk Deck With Side Storage Bins |
| Drivetrain: |
|
| Notes: |
|
| Last Updated: |
1/23/2013 |
| Hits: |
19207 |
2007-LH_seat_conn_view.jpg
2077 hits | 73.64 KB | Posted: 3/22/10
this is the 2007 LH custom connector view, you won't find this in the wiring diagrams manual published by Ford or anywhere else but here.
IMG_1207.JPG
1553 hits | 70.92 KB | Posted: 4/4/10
2007 restraint control module riveted in place to the 2003 LX seat frame in the same spot as the 2003 RCM was in.
2003-RH_seat_conn_view.jpg
1289 hits | 62.36 KB | Posted: 3/7/10
this is the 2003 RH seat custom connector view, you won't find this in the wiring diagrams manual published by Ford or anywhere else but here.
I will only be using pins 7, 11, 13 and 14 only from this harness.
IMG_1083[1].JPG
1239 hits | 80.05 KB | Posted: 3/7/10
2003 connector view. left to right
1. side air bag module impact (2 wire connector)
2. basic seat connector (14 wire connector)
3. power seat connector (6 wire connector)
IMG_1114[1].JPG
1181 hits | 86.94 KB | Posted: 3/17/10
use this area pictured at the end of the wiring runner where the kick panel would go, for the ground wire 57 (BK) and tap into power from the police trunk release button located below the raido, wire 517 (BK/WT).
NOTE: that wiring off to the left ...
power_seat_motor.jpg
1169 hits | 61.45 KB | Posted: 3/7/10
this is the floor connector view of the power seat motor harness, this connector type and wiring color codes didn't change from 1999-2008.
IMG_1198.JPG
1087 hits | 87.27 KB | Posted: 4/4/10
wiring is in place and lined up over the 2003 harness. i didnt remove the 2003 harness and the seat still functions 100% stock with both in place as seen above.
airbag_conn_2003-RH.jpg
999 hits | 40.12 KB | Posted: 3/22/10
this is the floor connector view of the small connector for the air bag module RH passangerside in 2003 seats.
IMG_1200.JPG
979 hits | 80.96 KB | Posted: 4/4/10
connector view, I'll still be using 4 wires from the 2003 connector for power seat and recline.
connectors from left to right
powerseat - 2003 seat - 2007 seat.
Maintenance & Modification Logs
This user hasn't added any log entries, yet.
