File 83 of 429
Prev | Next

Share This
Url
Tag
Img
Thumb

enginebay93lhr.jpg '93-95 Bronco Engine Bay LHR
IF THE IMAGE IS TOO SMALL, click it.

This cruise servo was only used from '93-04.
Only '93-96 Broncos have 4WABS.
'96-up DLC is under the dash.

To remove the EEC, back out the 10mm bolt recessed in the center of its connector, set the connector aside, remove the 2 11mm nuts (above & below), then pull the EEC & its weather seal straight forward into the engine bay.  It may be necessary to bend the plastic wheelwell liner to make room.

See also:

[url=https://www.supermotors.net/registry/media/911881][img]https://www.supermotors.net/getfile/911881/thumbnail/cruise93.jpg[/img][/url] . [url=https://www.supermotors.net/registry/media/470468][img]https://www.supermotors.net/getfile/470468/thumbnail/tsb951511pipstall.jpg[/img][/url] . [url=https://www.supermotors.net/vehicles/registry/media/148976][img]https://www.supermotors.net/getfile/148976/thumbnail/5.8l-spout.jpg[/img][/url] . [url=https://www.supermotors.net/vehicles/registry/media/862996][img]https://www.supermotors.net/getfile/862996/thumbnail/dlcjumper.jpg[/img][/url] . [url=https://www.supermotors.net/registry/media/245234][img]https://www.supermotors.net/getfile/245234/thumbnail/dlc-eeciv.jpg[/img][/url] . [url=https://www.supermotors.net/vehicles/registry/media/892730][img]https://www.supermotors.net/getfile/892730/thumbnail/eecconnectors.jpg[/img][/url] . [url=https://www.supermotors.net/registry/media/280797][img]https://www.supermotors.net/getfile/280797/thumbnail/brake-booster-installation.jpg[/img][/url] . [url=https://www.supermotors.net/registry/media/895333][img]https://www.supermotors.net/getfile/895333/thumbnail/mastercyl9496.jpg[/img][/url]

See also:
[url=https://www.fordparts.com/FileUploads/CMSFiles/18376%20Pigtail%20Book%202016.pdf]MotorCraft 2016 Wiring Pigtail Guide[/url]
enginebay93lhr.jpg | Hits: 10692 | Posted on: 10/8/10 | View original size (687.61 KB)

'93-95 Bronco Engine Bay LHR
IF THE IMAGE IS TOO SMALL, click it.

This cruise servo was only used from '93-04.
Only '93-96 Broncos have 4WABS.
'96-up DLC is under the dash.

To remove the EEC, back out the 10mm bolt recessed in the center of its connector, set the connector aside, remove the 2 11mm nuts (above & below), then pull the EEC & its weather seal straight forward into the engine bay. It may be necessary to bend the plastic wheelwell liner to make room.

See also:

. . . . . . .

See also:
MotorCraft 2016 Wiring Pigtail Guide